Installation – Baby Trend Flex-Loc Infnat Car Seat CSO190AD809 User Manual
Page 48
proper angle of recline, place a rolled
towel, or car seat noodle, under the
base at the foot end to achieve the
correct position. (Fig. 48-1)
2. Safety Seat without Base: Check
that the Safety Seat is level side to side
on the vehicle seat. Check the level
indicator as shown in Fig. 46-2.
• If the Seat Angle Indicator shows NO
red, the seat is installed at the proper
level of recline.
• If the Seat Angle Indicator shows
ANY
red
, the Safety Seat is either
too upright
or too reclined
. If the Safety Seat is
too reclined adjust the Safety Seat as
shown in Fig. 48-2 until the level indicator
shows
NO red
. If the Safety Seat is too
upright, place a tightly rolled towel, or
car seat noodle, under the foot end of
the Safety Seat until the level indicator
shows
NO red
. (Fig. 48-3) Re-tighten the
vehicle seat belt as instructed in section
Securing the Safety Seat or Base in
the Vehicle.
7.0
INSTALLATION
48
Fig. 48-1
Fig. 48-2
Fig. 48-3