Lukas PC 650 - Manual (Page 10)

10
3. Proper use
You can obtain accessories and replacement parts for the hydraulic power unit from your
authorised LUKAS dealer!
WARNING / CAUTION / ATTENTION!
The safety instructions in this operating instruction manual concerning the site of
erection and type of erection must always be observed!
LUKAS units type GC and PC 650 are
not explosion protected!
LUKAS hydraulic power units are specially designed to supply LUKAS rerailing equipment
with hydraulic fl uid and pressure. LUKAS rerailing equipment, such as a traversing unit or
one or more hydraulic cylinders is used for erecting and rerailing of rail-bound vehicles.
Their use for supplying pressure / fl uid to rescue equipment of other manufacturers is
possible, yet requires the technical inspection and approval by LUKAS in each individual
case.
The equipment is not designed to operate without hoses or equipment (operating time
without hoses or equipment < 15 minutes).
The equipment type groups GC and PC 650 have been developed for rerailing technology
and for use in combination with the control table.
When working with the units described here, make sure that participating and non-participating
persons in the vicinity of the work and during the lifting procedure are not endangered by the
connected hoses and equipment.
ATTENTION!
When selecting the units to connect to the unit, bear in mind that the maximum
possible useable volume of hydraulic fl uid is limited.
The sum of the max. required operating volume of oil (hydraulic fl uid) of all
connected equipment must not exceed the maximum possible usable volume
of the power unit!
NOTE:
Always register your hydraulic unit on the LUKAS Hydraulik GmbH internet site.
This is the only way to guarantee your extended warranty cover.
Before you use couplings from a different company, you must contact LUKAS or
an authorised dealer.