Advance Adapters 300377A - Manual

ADVANCE ADAPTERS INC. P/N: 300377A
P.O. Box 247, 4320 Aerotech Center Way New Item: (9/09)
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-07-14
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
JK ATLAS CONTROL MODULE
for NEW POLLAK SWITCHES
1. 1 42R800 CONTROL MODULE KIT
KIT INCLUDES
2 8-32 SOCKET HEAD CAP SCREWS
2 8-32 NYLON LOCK NUTS
5 1/4"x1" HEAT SHRINK
1 3 WIRE DELPHI CONNECTOR
1 2 WIRE DELPHI CONNECTOR
10 CABLE TIE - BLACK 4"
2. 1 300378-4WD 4WD PIGTAIL
3.. 1 300378-LR LOW RANGE PIGTAIL
4. 2 300364 NEW LOW RANGE SWITCH
KIT CONSISTS OF:
No.
Qty Part No. Description
Introduction:
The JK control module is the only way of keeping all the stock
functions operational when upgrading to an Atlas transfer case.
This Module lights the dash lights in both high and low range as well
as the settings on the ESP when in 4WD and lockers and swaybar
disconnect on the Rubicon models. This kit is designed for the Atlas
2 speed but can be used on a 4 speed by connecting a additional
low range switch to the planetary housing and splicing that switch
into the lead from the low range switch from the Atlas case.
** Note**
2012 and Up Jeep JK Autos:
JK 2012 and newer Jeeps equipped with an au-
tomatic transmission will also require a Trans-
mission Control Module flash to operate correctly
with the new Atlas transfer case. Jeep coded the
stock transfer case ratio of either the 2.72:1 or
the 4.0:1 into this module, and any different ratio
in the transfer case will put the vehicle into a limp
mode. A Jeep programer like a A.E.V. Procal or
the Bully Dog with the transfer case ratio option
in needed and we sell both of these programers.
Unfortunately, the Atlas 4 speed is not an option
in these newer JKs with the automatic.
The exact ratios for the Atlas are required for re-
programming the module. We round up or down
to the decimal on our ratios; however, the Jeep
computer module will accept the three places
right of the decimal. The ratios are as follows:
2.0:1 is exactly 2.087:1, 3.0:1 is 3.030:1, 3.8:1 is
3.824:1, 4.3:1 is 4.286:1, and 5.0:1 is 5.048:1.
OPTIONAL ITEMS:
24-AEV PROGRAMER
24-40440 BULLY DOG