JLG 4017 Platform Operator Manual - Manual (Page 39)

Section 4 - Platform
4-1 31200029
SECTION 4 - PLATFORM
4.1 APPROVED PLATFORMS
To determine if platform is approved for use on the specific telehandler you are
using, perform the following prior to installation.
• The platform model (1) and part number (2) on the platform identification plate
must match the platform model (4) and part number (5) on the telehandler
identification plate.
If the above condition is not met, do not use the platform attachment. The
telehandler may not be equipped for the attachment or the attachment may not be
approved for the model telehandler being used. Contact JLG or your local distributor
for further information.
4.2 UNAPPROVED PLATFORMS
Do not use unapproved platforms for the following reasons:
• JLG cannot establish range and capacity limitations for “will fit,” homemade,
altered, or other non-approved platforms.
• An overextended or overloaded telehandler can tip over with little or no warning
and cause serious injury or death to the operator and/or those working nearby.
• JLG cannot assure the ability of a non-approved platform to perform its intended
function safely.
WARNING
Use only approved attachments. Attachments which have not been approved for
use with your telehandler could cause machine damage or an accident resulting
in death or serious injury.
OZ1670
P/N
AERIAL PLATFORM
S/N
MODEL
1
2
P/N
TRUCK S/N
AERIAL PLATFORM APPLICATION
PLATE S/N
This truck can be combined with the aerial platform:
MODEL
HOMOLOGATION No.
3
4
TELEHANDLER IDENTIFICATION PLATE PLATFORM IDENTIFICATION PLATE