JLG 4017 Platform Operator Manual - Manual (Page 47)

Section 6 - Lubrication & Maintenance
6-1 31200029
SECTION 6 - LUBRICATION & MAINTENANCE
6.1 INTRODUCTION
Service the product in accordance with Section 6 of the Operator & Safety Manual
supplied with telehandler and the maintenance schedule on the following pages.
Service intervals are based on machine usage of 1500 hours annually. Use of your
product may vary significantly and you must adjust service frequency for your usage
to obtain maximum service life.
Note: Failure To Use JLG Hydraulic Filter Elements Could Void Warranty.
Clothing and Safety Gear
• Wear all the protective clothing and personal safety devices issued to you or
called for by job conditions.
• DO NOT wear loose clothing or jewelry that can get caught on controls or moving
parts.
6.2 GENERAL MAINTENANCE INSTRUCTIONS
Prior to performing any service or maintenance on the telehandler, follow the
“Shut-Down Procedure” on page 3-3 unless otherwise instructed. Ensure
telehandler is level for proper fluid readings.
• Clean lubrication fittings before lubricating.
• Apply a light coating of engine oil to all linkage pivot points.
• Intervals shown are for normal usage and conditions. Adjust intervals for
abnormal usage and conditions.
WARNING
CUT/CRUSH/BURN HAZARD. Do not perform service or maintenance on the
machine with the engine running, with the exception of the transmission fluid level
check. Failure to comply could cause death or serious injury.