JLG 400CRT ANSI Service Manual - Manual (Page 13)

SECTION 1 - SPECIFICATIONS
3121111 – JLG Lift – 1-5
1.6 PRESSURE SETTINGS
Main Relief - 3300 psi ± 50 psi (228 bar ± 3.4 bar)
Steer Relief (Left) - max 2600 psi (179 bar)
Steer Relief (Right) - max 1600 psi (110 bar)
Lift Pressure - 330CRT - 2300 psi (159 bar)
400CRT - 2500 psi (172 bar)
Leveling Jacks Valve (If Equipped) - 1200 psi (83 bar)
1.7 SERIAL NUMBER LOCATIONS
For machine identification, a serial number plate is affixed
to the machine. The plate is located on the left side of the
machine between the fuel tank and the rear wheel. In
addition, should the serial number plate be damaged or
missing, the machine serial number is stamped on the top
of frame between the front wheels.
1.8 LIMIT SWITCHES
The machine is equipped with the following limit switches:
High Drive Speed Cut-Out - High drive speed is cut out
when platform is raised above stowed (fully lowered) posi-
tion.
Tilt Alarm - 3° - A horn is sounded and a warning light is
illuminated when the machine is operated on a slope that
exceeds 3° with the platform raised. If the machine is oper-
ated on a 3° slope with the platform completely lowered,
only the warning light is illuminated.
Drive Cut-Out (400CRT only) - Drive function is cut-out
when the machine reaches a preset height of 30 ft. (0.8
m).
Serial Number Plate
Serial Number
(Stamped)
Figure 1-2. Serial Number Location