JLG 400CRT ANSI Service Manual - Manual (Page 40)

SECTION 2 - PROCEDURES
2-26 – JLG Lift – 3121111
NOTE: When configuring a CRT scissors machine, the
machine configuration must be completed before
any personality settings can be changed. Changing
the personality settings first and then changing the
model number of the machine configuration will
cause the personality settings to return to default
values.
Table 2-5. Machine Configuration Programming Information
Configuration Digit Number Description Default Num-
ber
1
(Model #)
1
2
3 260 CRT
330 CRT
400 CRT 0
2
(Engine Selection)
0
1
2 750 Dual Fuel
905 Diesel
1105 Diesel
0
3
(Tilt)
0
1 No Cutout
Cutout lift up and drive if tilted and elevated. Required for AUS and BRZ markets
0
4
(Drive Cutout)
0
1 No drive cutout switch installed.
Cuts out drive when deck is elevated above a predetermined elevation
(Default for 400 CRT)
0
5
(Control Direction)
0
1 FWD & LIFT up
FWD & LIFT dn (for future use)
0
6
(Leveling Jacks)
0
1 No
Yes
0
7
(Axle Type)
0
1
2 Domestic & CE Fixed
DOmestic Oscillating
CE Oscillating
2