JLG LSS Scissors - Manual (Page 58)

SECTION 6 - SERVICE - (RS)
6-6 – JLG Lift – 3124288
10RS Angle Sensor Removal (RS)
(See Figure 6-1. and Figure 6-2.)
1. Ensure that the platform is stowed and the machine
is on level ground.
2. Disconnect power at the batteries.
3. Locate the Angle Sensor at the back of the machine.
4. Disconnect the Angle Sensor’s electrical connec-
tion.
5. Remove the Angle Sensor.
10RS Angle Sensor Installation (RS)
1. Install the Angle Sensor with the mounting hard-
ware.
2. Reconnect the Angle Sensor’s electrical connector.
3. Reconnect power at the batteries.
4. Recalibrate the machine’s Angle Sensor.
5. Recalibrate the machine’s Load Sensing System.
6RS Angle Sensor Removal (RS)
1. Ensure that the key switch is set to ground mode.
2. Engage lift up from the ground panel until the plat-
form has elevated high enough to engage the lift cyl-
inder safety prop.
3. Engage the platform safety prop.
4. Lower the platform on to the safety prop and con-
tinue to engage lift down for 1 second after the plat-
form makes contact with the safety prop.
5. Disconnect power at the batteries.
6. Disconnect the Angle Sensor’s electrical connec-
tion.
7. Remove the Angle Sensor.
6RS Angle Sensor Installation (RS)
1. Install the Angle Sensor with the mounting hard-
ware.
2. Reconnect the Angle Sensor’s electrical connector.
3. Reconnect power at the batteries.
4. Turn machine on and engage lift up from the ground
panel so that the safety prop can be disengaged.
5. Lower the platform to the stowed position.
6. Recalibrate the machine’s Angle Sensor.
7. Recalibrate the machine’s Load Sensing System.
1932RS/6RS 3248RS/10RS
1. Platform Gate
2. LSS Scissor Arm Angle Sensor (rear plate shown cutaway)
3. Platform Entry Ladder 1. Elevation Limit Switch Location
2. LSS Scissor Arm Angle Switch (scissor arms shown cutaway)
3. Platform Entry Ladder
Figure 6-3. LSS - Scissor Arm Angle Sensor - (RS)