AirLive WT-2000ARM User Manual
Page 21
AirLive WT-2000ARM User’s Manual
16
Note: Please make sure that the router’s DHCP server is the only DHCP server available on
your LAN.
Windows NT
1. Click
the
Start button and select Settings, then click Control Panel. The Control Panel window will
appear.
2. Double-click
Network icon. The Network window will appear. Select the Protocol tab from the
Network window.
3. Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not installed, click
the Add button to install it now. If TCP/IP is installed, go to step 5.
4. In
the
Select Network Protocol window, select the TCP/IP Protocol and click the Ok button to start
installing the TCP/IP protocol. You may need your Windows CD to complete the installation.
5. After you install TCP/IP, go back to the Network window. Select TCP/IP from the list of Network
Protocols and then click the Properties button.
6. Check each of the tabs and verify the following settings:
IP Address: Select Obtain an IP address from a DHCP server.
DNS: Let all fields are blank.
WINS: Let all fields are blank.
Routing: Let all fields are blank.