AirLive WT-2000ARM User Manual
Page 47
AirLive WT-2000ARM User’s Manual
42
z
IP Filter Rule Editing
Parameter
Description
IP Filter Rule Index
This is the item number to record the setting rule.
Active
Select “Yes” to enable the current rule, select “No” to cancel the
current rule.
Source IP Address
Enter the start IP Address which will be monitored.
Subnet Mask
Enter the Subnet Mask based on the Source IP Address.
Port Number
LAN users use port numbers to distinguish one network application
over another such as 21 is for FTP service. The port number range
is from 0 to 65535. It is recommended that this option be configured
by an advanced user.
Destination IP Address
Enter the start IP Address which will be monitored.
Subnet Mask
Enter the Subnet Mask based on the Destination IP Address.
Port Number
This is the port or port ranges that define the application.
Parameter
Description
Protocol
It is the packet protocol type used by the application. Please select
“TCP”, “UDP” or “ICMP”. For example, FTP service, you have to
select “TCP”.
Rule Unmatched
Select action for the traffic unmatching current rule. “Forward” is to
leave it pass through; “Next” is to check it by the next rule.
z
IP Filter Listing
The IP Filter Listing will list the IP Filter rules you have configured. You can review the settings here.