Bosch B20CS5 - Manual (Page 13)

14
Operating the ice
maker
When the freezer compartment has
reached its freezing temperature,
water flows into the ice maker and
freezes into ice cubes. When the ice
cubes are ready, they are
automatically discharged into the ice
cube container.
Occasionally the sides of the ice
cubes stick together. When they are
conveyed to the outlet opening, they
usually break away from each other.
When the ice cube container is full,
ice making switches off
automatically.
The ice maker can make approx.
100 ice cubes within 24 hours.
Do not place any bottles or food
for rapid cooling in the ice cube
container. The ice maker may
become blocked and be
damaged.
When the appliance has been
switched on, it takes approx.
24 hours until the first batch of ice
cubes are ready.
When ice cubes are being made, the
buzzing water valve, the water
flowing into the ice cube tray and the
falling ice cubes can be heard.
Drinking water quality
All materials used in the drinks
dispenser are odorless and
tasteless.
If the water has an aftertaste, this
may be caused by:
- Mineral and chlorine content of
the drinking water.
- Material of the domestic water
line or connection line.
- Freshness of the drinking water
(if water has not been dispensed
for a long time, the water may
have a stale" taste. In this case
dispense approx. 15 glasses of
water and pour away).
d CAUTION d
The enclosed water filter will filter
only particles out of the supply
water, not bacteria or microbes.
Dispensing water
q Press the button until the
symbol lights up.
q Press the glass against the
dispenser pad. The water stops
running when the glass is
removed from the pad.
Tip:
The water from the water dispenser
is cooled to a palatable temperature.
If you would like the water colder,
place ice cubes in the glass before
dispensing the water.
Dispensing ice
q Press the button until the
symbol for ice cubes or crushed
ice lights up.
q Press a suitable receptacle
against the dispenser pad.
i Remove the receptacle from the
dispenser pad when it is approx.
half full. Ice in the discharge may
cause the receptacle to overflow
or block the discharge.
Removing and cleaning
the water collecting
tray
Spilled water collects in the water
collecting tray. The water collecting
tray can be emptied and cleaned by
pulling it out.
Removing and cleaning
the ice cube container
If ice cubes have not been
dispensed for a prolonged period,
they will shrink, have a stale taste
and stick together.
q Pull out the container, empty
and clean with lukewarm water.
q Thoroughly dry the container
and screw conveyor to prevent
new ice cubes from sticking.
Inserting the ice cube
container
q Push the ice cube container all
the way back onto the supports
until it locks into position.
q If the container cannot be
pushed all the way back, twist
the screw conveyor in the
container.
Ice cube production continues.