Bosch B20CS5 - Manual (Page 22)

23
Unscrewing the doors
If the appliance will not fit through
the house door, the appliance doors
can be unscrewed.
We recommend that installation is
carried out by our customer service.
Unscrewing the freezer
compartment door
q Remove lower cover.
q Loosen the hose connection:
- Loosen the hose clips on
the hose connection.
- Press the clamping ring in
the direction of the arrow
and simultaneously pull the
hose out of the hose
connection.
q Remove the upper hinge
cover (1).
q Disconnect the electrical
plugĆandĆsocket connections
(2).
q While holding the door, unscrew
the hinge screws on top (3).
q Lift the door off the lower hinge
pin.
Remove and deposit the door
with care! Do not damage the
water line.
Unscrewing the refrigerator
compartment door
q Unscrew the refrigerator
compartment door in the same
way (the refrigerator
compartment door does not
feature any electrical
plugĆandĆsocket connections or
hose connections).
Warning:
Before installing the doors in reverse
sequence, ensure that the appliance
is level in the installation location.
Connecting the
appliance to the water
supply
The water may be connected only by
a competent fitter according to the
local regulations of the appropriate
water supply company.
Connect the appliance to a cold
water line.
- Minimum pressure:
20 p.s.i. (1.4 bar)
- Maximum pressure up to
100 p.s.i. (6.9 bar)
The tap for connection of the water
line should be freely accessible.
q Loosen the screws and remove
the motor compartment cover.
q Connect the connecting line to
the solenoid valve (¼").
q Connect the connecting line to
the tap.
q Using the clip, attach the
connecting line to the rear panel
of the appliance.
q Place the connecting line in
loops or coils so that the
appliance can be moved away
from the wall.