Bosch B20CS5 - Manual (Page 5)

6
Installation
d CAUTION d
Do not install the appliance:
- outdoors,
- in an environment with dripping
water,
- in rooms which are at risk of
frost.
The appliance is very heavy ć
move and install carefully.
Installation location
Install the appliance in a dry, well
ventilated room. If installation near
a heat source is unavoidable, use
a suitable insulating plate or observe
the following minimum distances to
a heat source:
Observe the following minimum
distances to heat sources:
- 1
1 /
4
" (3 cm) to an electric
cooker.
- from an oil or solidĆfuel cooker
11 3 /16" (30 cm).
The floor on which the appliance is
to be installed must be rigid.
If required, reinforce the floor.
To ensure that the ice maker
functions correctly, the appliance
must be upright. To ensure that the
doors can open all the way, observe
lateral minimum distances when
installing the appliance in a corner or
recess (see section on Appliance
dimensions").
Observe ambient
temperature and
ventilation
The climatic class can be found on
the rating plate and indicates the
ambient temperatures at which the
appliance can be operated.
Climatic class Permitted ambient
temperature
SN 50 ° F to 89.6 ° F
(+10 ° C to 32 ° C)
N 60.8 ° F to 89.6 ° F
(+16 ° C to 32 ° C)
ST 64.4 ° F to 100.4 ° F
(+18 ° C to 38 ° C)
T 64.4 ° F to 109.4 ° F
(+18 ° C to 43 ° C)
Ventilation
Never cover the ventilation openings
in the base panel. Otherwise, the
refrigerating unit must work harder
and the power consumption is
increased.
Electrical connection
d WARNING d
Electrical Shock Hazard
- Plug into a grounded 3 prong
outlet.
- Do not remove ground prong.
- Do not use an adapter.
- Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
The appliance comes with an UL
listed, 3Ćwire power supply cord.
The appliance requires a 3Ćwire
receptacle.
The receptacle must be installed by
a licensed electrician only.
d WARNING d
Improper connection of the
equipment grounding conductor
may result in electric shock. Have
the appliance checked by a
qualified electrician or service
technician if you are in doubt as
to whether the appliance has
been properly grounded.
Water connection
Have a technician install the
appliance and connect it to the
water supply according to the
enclosed installation instructions.
A cold water connection is required
for operation of the automatic ice
maker. The water pressure must be
between 20 and 100 p.s.i.
(1.4ć6.9 bar).
The installation must comply with
local plumbing regulations and local
and state laws.
A separate shutĆoff valve must be
installed for the appliance water
connection.
The shutĆoff valve for the water
connection must not be behind the
appliance. It is recommended to
place the shutĆoff valve directly next
to the appliance (base unit) or in
another easily accessible location.
Before switching on
the appliance for the
first time
After installing the appliance, wait at
least ½ hour before switching on the
appliance. During transportation the
oil in the compressor may have
flowed into the refrigeration system.
Before switching on the appliance
for the first time, clean the interior of
the appliance (see Cleaning the
appliance").
i For more informations see the
section Installation
instructions".