Atop Technology MB5001C User Manual - Manual (Page 9)

User Manual Version 1.0
MB5001C series 1-port Modbus Gateway
Copyright © 2010 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
8
2.1.2 COM Port LED
Message Description
Off No data is transmitting on COM port
Blinking Data is transmitting on COM port
Table 2. COM Port LED Message
2.1.3 RUN LED
Message Description
On Jumper JP1 Pin1 and Pin2 are shorted to disable
AP firmware running
Blinking (rate: 0.5 Sec) AP firmware is running normally
Table 3. RUN LED Message
2.2 Installation Procedures
Step 1: Connect MB5001C to power source using 5V DC Jack (Note that DC Jack is 5V only, and only
use it with a power adaptor), or 9~30V DC Terminal Block power source.
Note：MB5001C provide two power inputs can be connected simultaneously to live DC
power sources. Anyone of the power inputs fails, the other live source acts as a backup
to support power needs automatically. The redundant dual DC power inputs give one
extra assurance of non-stop operation.
MB5001C : 5V DC Jack or DC 9-30V 3-pin Terminal Block power input
MB5001C-Sis: DC 9-30V 3-pin Terminal Block power input
Step 2: Connect MB5001C to Ethernet network. Use a standard straight-through Ethernet cable when
one connect it to a hub/switch, one also can connect it to ones PC„s Ethernet port via a
cross-over Ethernet cable for easy set up. However, in this case one need to make sure ones
PC is in the same network sub-net as MB5001C.
Step 3: Connect MB5001C ‟s serial port to a serial device.
Step 4: Placement options. One can mount MB5001C to a wall/panel (Mounting screws included) or
Din-Rail rack (Require optional item model: Din-Rail-Kit DK-25).