Barranca Diamond MK-5009G/5013G - Manual (Page 18)

18
Dry Blade Operation
(A)
Loosen Water Pump Drive End
Pivot Plate front and rear
retaining bolts
(B)
Pivot front of Water Pump Drive
End Pivot Plate up and tighten
the retaining bolts
(C)
Move Water Pump Assembly
to the outside of the
Water Basin
Failure to perform the following steps will lead to premature pump failure. NOTE:
Cutting Setup
(A)
Set edge of Cutting
Guide to desired cut length on
Ruler/Stop
(B)
Set material against
Adjustable Cutting
Guide and Ruler/Stop
(C)
Unlock the Cutting Head
1. While the MK-5000 can cut the materials listed earlier in this document, it is specifically designed to cut
concrete masonry. Cutting another material will reduce the life of the diamond blade.
2. Due to the material being cut, the diamond blade should not require dressing. If dressing is required, use
a soft stone such as sandstone.
NOTE:
CAUTION DO NOT FORCE the blade to cut, it will do the job better and safer at rate for which it was designed.
(D)
Adjust the height of the Cutting
Head as necessary
MK-5000G SETUP