Barranca Diamond MK-5009G/5013G - Manual (Page 6)

6
DO NOT OVERREACH.
Keep proper footing and balance at all times by not overreaching.
MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for the best and safest performance. Always follow maintenance instructions for lubricating
and when changing accessories.
SHUTDOWN TOOL.
The saw should always be shutdown before servicing or when changing accessories such as blades, bits, cutters, and
the like.
USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recommended accessories. Using improper accessories may increase the risk of per-
sonal or by-stander injury.
NEVER STAND ON THE TOOL.
Serious injury could occur if a power tool is tipped, or if a cutting tool is unintentionally contacted.
NEVER LEAVE TOOL RUNNING UNATTENDED – TURN POWER OFF.
Do not leave a tool until it comes to a complete stop. Always turn a power tool OFF when leaving the work area, or,
when a cut is finished.
CHECK FOR DAMAGED PARTS.
Before using a power tool, check for damaged parts. A guard or any other part that is damaged should be carefully
checked to determine it would operate properly and perform its intended function. Always check moving parts for
proper alignment or binding. Check for broken parts, mountings and all other conditions that may affect the operation of
the power tool. A guard or any damaged part should be properly repaired or replaced.
DIRECTION OF FEED.
Always feed work into a blade or cutter against the direction of rotation. A blade or cutter should always be installed
such that rotation is in the direction of the arrow imprinted on the side of the blade or cutter.
MK-5000G SAFETY
DO NOT FORCE THE TOOL.
A power tool will do a job better and safer operating at the rate for which it was designed.
USE THE RIGHT TOOL.
Do not force a tool or an attachment, to do a job that it was not designed to do.
WEAR PROPER APPAREL.
Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry that may be caught in moving parts.
Nonslip footwear is recommended. Wear protective hair covering to contain long hair.
SECURE WORK.
Clamps or a vise should be used to hold work whenever practical. Keeping your hands free to operate a power tool is
safer.
KEEP CHILDREN AWAY.
All visitors and children should be kept a safe distance from work area.
MAKE WORKSHOP KID PROOF.
Make the workshops kid proof by using padlocks, master switches or by removing starter keys.