Condux Fiber Optic Cable Puller Trailer - Manual (Page 13)

13
• Do not expose electronic control box to water.
• Do not remove cover of electronic control box (no user-serviceable parts
inside). Refer servicing to qualified personnel.
• The electronic control box power switch should be in the off position
before connecting or disconnecting any cords.
1. Connect the male end of the 5-pin sensing cord to the female connector on the
Electronic Control Box labeled “LOAD CELL”. (figure 16) Connect the female end
of the cord to the male receptacle located near the load cell. (figure 16a). Before
making these connections, ensure the receptacles are free of dirt and moisture.
Do not modify this cord’s length.
Tighten the connector collars over the threaded portion of the receptacles. This
prevents the cord from coming loose during operation. This cord is necessary to
measure the tensions sensed by the load cell.
2. Connect the male end of the 3-pin footswitch control cord to the female connector on
the Electronic Control Box labeled “FOOTSWITCH” figure 16b). Connect the female
end of the control cord to the male receptacle located on the foot control valve
assembly figure 16c).
NOTE: If the connector on the foot switch is 2-pin, use the patch
cord (08675926) included in the upgrade kit (08675920) to convert to the required
connection. Before making these connections, ensure the receptacles are free of dirt
and moisture.
Do not modify this cord’s length.
Figure 16 Figure 16a
Figure 16b Figure 16c