Condux Fiber Optic Cable Puller Trailer - Manual (Page 19)

19
D. DISCONNECT THE ELECTRONICS
!DANGER: The Electronic Control Box is an electrical device.
Electric shock hazard exists that could result in severe personal
injury or death. Observe the following precautions to avoid
electrical hazards:
1. Do not remove cover of Electronic Control Box. No user
serviceable parts inside. Refer servicing to qualified
service personnel.
2. The Electronic Control Box power switch should be in the off
position before connecting or disconnecting any cords.
1. Turn off Electronic Control Box before disconnecting any cords.
2. Remove power supply cord at the power pack and Electronic Control Box.
Wrap and stow in trailer.
3. Disconnect the Electronic Control Box control cord at the cable puller. Do
not disconnect the control cord at the Electronic Control Box, it is
permanently attached.
Additional Takedown Procedures
A. REMOVE CAPSTAN FROM CABLE PULLER
1. Push in on the capstan and rotate counterclockwise until it springs
out slightly.
2. Align slot on capstan with the pins on spindle and pull off.
3. Mount the capstan on the trailer by sliding the hub of the capstan over the
spindle mount on the trailer (figure 21). Capstan must be mounted exactly
as shown to prevent damage. Tie down with strap (supplied). Span a
minimum of three capstan spokes with the tie down strap for a tight fit.
!CAUTION: The cable puller is heavy (125 lbs.). Lift only with
proper equipment or sufficient man power. Personal injury may
result if improper lifting practices are used.
B. RETURN CABLE PULLER TO TRAVEL POSITION
Follow the procedure below if you have moved the cable puller from its travel
position. If you have used the remote mounting stand, it must be secured back on
the trailer before returning the cable puller to the travel position.
1. The center position is the only travel position recommended for the cable
puller. This mount does not require the additional mount used for the side
mount locations.
2. Lower the cable puller onto the center mount and pin in place. The cable
puller must travel with the capstan spindle pointing toward the
passengers side of the trailer (figure 21). Other components will not stow
properly if this position is not used.
10.