Condux Fiber Optic Cable Puller Trailer - Manual (Page 20)

20
C. LOAD FOOT CONTROL UNIT
Set foot control into travel hold on trailer bed (figure 22). Place hoses in
storage box.
D. PREPARE UNIT FOR TRANSPORT
1. Stow remaining equipment in compartment on trailer.
Trailer Towing Safety Instructions
!WARNING: Observe the following safety instructions when
transporting the Condux Fiber Optic Cable Puller Trailer. Observe
local, state, and federal laws governing trailer towing. Also follow
the tow vehicles operating instructions for trailer towing. Failure to
do so may result in severe personal injury and equipment damage.
1. Check that coupler hitch and ball or pintle hitch and hook are correct size.
2. Adjust trailer tongue to proper hitch height.
3. Secure fiber optic puller and capstan.
4. Disconnect electronics and turn off power pack.
5. Check trailer load for balance and capacity.
6. Attach trailer to towing vehicle.
7. Latch and lock ball coupler or pintle hook.
8. Cross safety chains beneath hitch and attach to towing vehicle.
9. Connect and check lighting.
10. Remove leveling jacks.
11. Remove wheel chocks.
12. Tighten wheel lug nuts and check tire pressure.
A.
APPENDIX
Figure 21 Figure 22