Condux Fiber Optic Cable Puller Trailer - Manual (Page 6)

6
C. ELECTRICAL COMPONENTS
The Electronic Control Box is an electrical device. Electric shock hazard exists
that could result in severe personal injury or death. Observe the following
precautions to avoid electrical hazards:
1. Do not operate in or near water. This includes setting the Electronic
Control Box on a wet surface or exposing it to rain.
2. Do not remove cover of Electronic Control Box. No user-serviceable parts
inside. Refer servicing to qualified service personnel.
3. The Electronic Control Box power switch should be in the off position before
connecting or disconnecting any cords.
Jobsite Floor Plan
A few minutes spent planning your equipment’s placement (layout) at the jobsite
will benefit both the operation of the equipment and the safety of your personnel at
the site. It is best to determine the layout of equipment before stabilizing and
leveling the trailer (section 5A). Condux recognizes that no two jobsites are the
same, but recommends a few general guidelines to get the most benefit and safest
operation from your Fiber Optic Cable Puller Trailer.
A. POSITION THE CABLE PULLER
Ultimately, the cable will be pulled from its exit point parallel to the capstan
(figure 4). Several options are available on the Condux trailer to achieve this. The
cable puller can be located in one of three mounts and rotated perpendicular or
parallel in each. Review these options using the accompanying diagrams and
determine where to position the trailer (figure 3).
B. REMOTE MOUNTING STAND
If no suitable puller position can be achieved on the trailer, a remote mounting
stand (supplied) may be used, see section 6B.
4.
LEFT SIDE CENTER
RIGHT SIDE
Figure 3