Set up the trailer – Condux Fiber Optic Cable Puller Trailer User Manual
Page 7
7
C. POSITION THE TRAILER
Position the trailer (in the position determined in 4A) with the tow vehicle. It is not
recommended that any other means be used to move the trailer.
Set Up The Trailer
It is essential that the trailer set-up instructions are followed in order that they
appear in this user guide and safety manual. Using the following procedures
will allow the trailer to be set up in a short period of time and yield optimum
performance.
A. STABILIZING AND LEVELING THE TRAILER
1. Use only the adjustable jacks (3 supplied, replacement jack part number
02290764) for trailer stabilizing and leveling. Jacks must be placed securely
only on jack mounts located on the trailer frame (figure 5). Do not attempt
to locate jacks in any other position! To secure a jack in position, align jack
with jack mount and insert safety pin. Raise and lower jacks by simply
rotating crank handle.
!WARNING:
Chock wheels and level trailer before setting up
cable puller and other pulling equipment. Use wheel chocks and
all three leveling jacks as described in the procedure below.
Failure to properly level trailer may result in the trailers unexpected
movement causing severe personal injury and equipment damage.
20°
ECB
OPERATOR
FOOT CONTROL
HAZARD AREA
Figure 4
5.