Condux Fiber Optic Cable Puller Trailer - Manual (Page 17)

17
!DANGER: No smoking or open flame in the work area. An
explosion hazard exists as the trailer houses a gasoline tank.
B. FINAL INSPECTION BEFORE STARTING POWER UNIT
1. Inspect the jobsite for safe equipment layout.
2. Be sure the trailer is stable and level.
3. Supply all jobsite personnel with safety equipment (section 3).
4. Check engine oil level. See Briggs & Stratton Owner’s Manual (supplied).
5. Check hydraulic fluid level.
6. Check hydraulic connections.
7. Check electronic connections if using the Electronic Control Box.
C. START THE POWER UNIT
1. Turn on the ignition switch.
2. The Hydraulic Power Pack has an electric starter. The battery must be
charged to start engine. Jump starting is not recommended.
3. Begin the cable pull. There is no information in this manual on the
operation of the Condux Fiber Optic Cable Puller. You must read and
understand all operating instructions and safety messages in the
Condux Fiber Optic Cable Puller User Guide & Safety Manual
(Part No. 08675199) before operating that equipment (figure 17 & 18).
Figure 17 Figure 18