Det-Tronics X3302 Multispectrum IR Flame Detector with HART User Manual

Page 18

Advertising

2.3

95-8613

ConFIgurATIon menu

1) Consecutive

oi Fails

This option allows the operator to select the number of consecutive oi failures

before an oi fault will be generated. Selectable range is 1 to 1000.

2) Temp setpoint

Internal target temperature that the heater will attempt to maintain (in degrees C).

3) heater setpoint

This option allows the operator to select the maximum amount of heater power

allowed, in percent of full power. (0% = heater shut off.)

CALIBrATIon menu

1) Loop test

This test allows the operator to manually set the analog signal output (

mA)

to a fixed user defined value.

2) d/A trim

This function allows adjustment of the

mA span factor.

3) Calibrate

This procedure calibrates the oi test signal for all three IR sensors.

1. Bypass/disable all Alarm outputs connected to the detector.

2. Thoroughly clean the sensor and oi reflector for each of the three sensors.

Check each of the three oi source openings for contaminants and clean as

needed.

3. Cover the detector with the provided cover.

4. Initiate oi Calibration. The detector performs the calibration automatically and

notifies the operator upon completion. The procedure takes approximately two

minutes.

5. Upon completion of oi calibration, remove the cover and return all alarm outputs

to service.

Configuration Menu

1) Consecutive Oi Fails

2) Temp Setpoint

3) Heater Setpoint

Device Setup Menu

1) Configuration Menu

2) Calibration Menu

3) Write protect

4) HART Setup

5) Real Time Clock

X3302 Root Menu

1) Fire (Yes/No)

2) Fault (Yes/No)

3) Device Info Menu

4) Command Menu

5) Device Setup Menu

Calibration Menu

1) Loop test

2) D/A trim

3) Calibrate Oi