ECOXGEAR TWCCDRW: Tunewriter II - Manual (Page 35)

35
1. Press the CD button to select “CD”.
2. Load a recorded CD-RW.
3. Press the ERASE button while in the stop mode.
(1). Wait until “Busy” disappear on the display. Never turn the power off nor unplug the
power cord.
(2). Press the PLAY/PAUSE button to begin erasing the last track.
(3). Press ERASE button to continue the next track.
“Er” and the last track number appear when the disc hasn’t been finalized. Each time the
ERASE button is pressed, the display changes as follows:
“Er” and the number of the last track recorded on the disc
Select this to erase the last track on the disc.
• This will not appear when only one track is recorded on the disc.
To ERASE All
Select this to erase all the tracks from the disc.
To cancel the erasing or un-finalizing process, press the STOP button.
4. (1). Press and hold the ERASE button until the display shows “Erase All”.
(2). Press PLAY button to begin to erase the tracks from the disc.
(3). The display will show 0000000 to confirm the disc is clear.
The remaining time for the operation appears in the display. When the operation has been
finished, the display returns to the track/time display.
During erasing/un-finalizing, no buttons will work.
• This operation cannot be undone. If you are going to erase a track or
tracks, make sure that they are recordings that you really want to erase.
A copied CD-RW disc copied from another unit cannot erase one
track at a time. However the entire disc can be erased.
8
19
13
19