ECOXGEAR TWCCDRW: Tunewriter II - Manual (Page 7)

7
• Use a soft anti-static cloth to gently wipe the record’s surface when the record has become
dirty.
• Keep records in their shield when not in use.
• Store records upright on their edges. Storing horizontally may warp record or curve the
record
• Avoid placing it in direct sunlight or close to a source of heat such as radiators, stoves. Also
avoid locations subject to vibration and excessive dust, heat, cold or moisture.
The stylus should last about 50 hours under normal use. However, it is recommenced that
the stylus be replaced as soon as you notice a change in sound quality. Prolonged use of a
worn-out stylus may damage the record. The highest speed setting of 78-RPM will wear out
the stylus more quickly.
How to Replace the Stylus
• Do not remove or bend the stylus.
• Do not touch the needle, which may injure your hand/finger.
• Turn off the unit’s power before you replace the stylus.
• Keep out of the reach of children.
• Avoid direct sunlight and being close to a source of heat.
Caution
Removing the old stylus
1. Set a screwdriver at the tip of the stylus and push
downward, in the direction “A” (as in the diagram).
2. Remove the stylus by pulling it forward and down.
Installing a new stylus
1. Hold the tip of the stylus and insert the other edge
by pressing toward the direction “B” (as in the
diagram).
2. Push upward in the direction “C” (as in the dia-
gram) until it locks at the tip.