Black Box LR1102A-T1/E1 - Manual (Page 75)

NAT Configuration Examples
77
10.4.3Port Address Translation (Many to one)
Figure 21 Mapping Multiple NAT Addresses to One Public IP Address
NAT allows multiple IP addresses to be mapped to one address.
There are two methods to configure Port Address Translation (PAT) on the Black Box gateway. In the first method, specify the
IP address to the
nat-ip parameter in the policy command. In the second method, create a pool of type PAT and then
attach it to the policy.
In PAT, multiple hosts can share the same IP address.
The PAT configuration shown in Figure 21 includes:
„
Private network address: 10.1.1.1—10.1.1.3
„
PAT address: 50.1.1.5
Method:1 – Specifying NAT address with the policy command
To configure this method of PAT, add the policy with the source IP address range, then specify the nat-ip address in the
policy command:
Method:2 – Attaching nat pool to the policy
To configure the second type of NAT, create a NAT pool with type pat and specify the IP address. Then add the policy with
the source IP address range. Finally, attach the NAT pool to the policy.
OPAL
50.1.1.5
INTERNET
10.1.1.3
10.1.1.2
10.1.1.1
Blackbox/configure> firewall corp
Blackbox/configure/firewall corp> policy 2 out address 10.1.1.1
10.1.1.3 any any nat-ip 50.1.1.5
Blackbox/configure/firewall corp/policy 2 out>
exit 2
Blackbox/configure>