Environmental Express SPE-Express with Cover User Manual
Page 23
Environmental Express, Inc.
800.343.5319/843.881.6560
22
2.4 Flushing the System
Once the user has configured the new hardware, the user will see nine active options on the main screen.
The next step is to perform a System Flush.
The System Flush will include performing a “Station Flush” for each of the 3 stations. The Flush will
ensure all air is removed from the reagent lines and that all hardware is clean. The instructions for the
“Station Flush” are located in section 2.4 and 3.2.2.
•
Press “Flush Station”.
•
Once “Flush Station” is pressed, a prompt will appear. Press the radio buttons to confirm that the
following steps have been completed:
o Install a new filter disk
o Install a clean, empty sample bottle
o Ensure that the bottle assembly is latched in the upright position.
o Ensure an aluminum evaporating pan is on the heater block (Note: there is no need to
pre-weigh to pan)