ETC Desire Series v1.6.0 User Manual - Manual (Page 33)

2
Installation and User Interface Overview 27
Data (D22)
Portable Model
The Portable D22 is provided with 5-pin XLR connectors on the back for data in and thru
connection to a DMX/RDM control network.
Canopy Mount
The D22 Canopy Mount fixture is provided with an attached power and Cat5 data cable.
A termination board is incorporated into the mounting plate for installation onto a voltage
separated junction box (provided by others) and provides termination for control wiring.
Figure-2.5 Termination Connectors.
• Connection of the D22 data cable to a provided screw-down connector, which is
pre-wired at the factory. The connector is plugged into the termination board. The
braided shield is connected inside the fixture and should not be connected in the
canopy.
• Connection of DMX/RDM input from the control source. This connection can be cable
type Belden 9729 (or equivalent) to the provided screw terminal. When using Cat5 (or
equivalent) cable type for DMX/RDM input, order a Cat5 termination kit from ETC (part
number 4100A1013). Cat5 termination instructions and an IDC connector are provided
with the termination kit.
• Connection of DMX/RDM thru to the next DMX device. This connection may also be
either Belden 9729 or Cat5. Order the appropriate DMX termination kit for the cable
type used from ETC (Belden 9729 use 4100A1012 or Cat5 use 4100A1013).
Termination instructions and the appropriate connector is provided with the termination
kit. Up to 32 DMX/RDM devices can be daisy-chained together per data run.
Track Mount
The Track Mount fixture power and data connections are made through the track mounting
adapter. No further wiring to the fixture is required. Refer to the Track installation
instructions for more information. ETC manuals are available for download at
http://www.etcconnect.com/downloads.aspx .
Data – (ORG)
Data + (W/ORG)
Cat5 (or equivalent) wire
termination to IDC connector
COM
BRN GRN
W/GRN
BLU
W/BLU
From a DMX/RDM source
Data – (Black) Data + (Red)
Belden 9729 (or equivalent) wire
termination to screw connector
4 to 8 = n/c
COM