Termination, Indicator lights, Termination indicator lights – ETC Desire Series v1.6.0 User Manual User Manual
Page 36
30
Desire Series v1.6.0 User Manual
Termination
D40XT – The last fixture on a DMX line must be terminated with a 120 ohm resistor
between pins 2 and 3.
D22 – The last fixture on a DMX/RDM line must be terminated with a 120 ohm resistor,
which is accomplished by one of the following.
•
Portable – The fixture is self terminated, therefore does not require other termination.
•
Canopy – Terminate with the S1 switch on the Termination Board. Set the switch to the
ON position to terminate the last fixture. All others on the DMX/RDM line must be set
to OFF.
•
Track Mount – Terminate with a DataTrack DMX Term Block, ETC Part # 7066A1030
installed at end of the track.
Indicator Lights
The indicator lights show the status of power input (blue), DMX input (green) and fixture
errors (red). When the DMX signal is lost, the green indicator flashes.
If the fixture status indicator is configured to Off, the indicator lights will not illuminate. For
more information, see