Packaging & contents, Dimensional drawings, Packaging & contents dimensional drawings – Johnson Systems EDI-120 Control Retrofit User Manual
Page 4
4
NOTE: All measurements are in inches.
Packaging & Contents
Each EDI-120 retrofit control system is shipped in a custom designed box and packaging for
protection of the unit. It’s recommended to keep the box and packaging stored in a safe place. In
the unlikely event that the system needs to be returned to the JSI Factory, the packaging will help
prevent shipping damage and maintain warranty.
Each EDI-120 retrofit control system includes all of the parts required to complete the retrofit.
Parts included with the EDI-120 retrofit control system:
• 10’ (3m) Belden 9829 (or equivalent) length of cable used to extend existing DMX cable(s).
• Two (2) 3-position breakaway connectors used to splice the existing DMX cable(s) to the
supplied DMX cable.
• Four (4) 1’ (30.5cm) extension ribbon cables used to extend the OEM P3, P4, P5 and P6
ribbon cables.
• 8’ (2.4m) #18 AWG green wire used to connect the EDI-120 retrofit control system chassis to
earth ground.
• 5’ (1.5m) #18AWG yellow and brown wires used to connect the fan control wiring from the
OEM P1 connector to the fan SSR. Typical installations already contain the control wiring
within the OEM P1 connector wiring, and these wires are not required.
• 10’ (3m) yellow CAT 5e patch cable used to daisy-chain the DMX-A and DMX-B between
multiple EDI-120 retrofit control systems. Only supplied when multiple EDI-120 retrofit
control systems are purchased.
• Four (4) #10-32 x 3/8” mounting screws used to secure the EDI-120 retrofit control system in
the EDI Mark VII dimmer rack.
Dimensional Drawings