Lenze Backup & Restore Data saving and restoring - Manual (Page 29)

Lenze · Backup & Restore · Software Manual · DMS 1.3 EN · 04/2014 · TD17
29
4 Creating a backup & carrying out recovery
4.2 Carrying out restore and auto-restore
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10. Restart controller (with connected USB stick) by mains switching.
• Contollers in Windows CE systems are automatically restarted.
• The backup selected is restored.
11. After the boot-up of the controller: Remove the USB stick from the controller.
4.2.2 Carrying out a restore: directly on the controller
[4-4] Illustration example: »Backup & Restore« under Windows CE ()

How to carry out a restore:
1. Connect a USB stick to the USB interface of the controller.
2. Start the »Backup & Restore« application.
3. Open the Restore/Update tab.
4. Select the Restore action
5. Available backups are shown.
6. Select a backup.
Further information:  Components of the backup designation ( 22)
7. Press Start.
A control file is written to the USB stick.
8. Restart controller (with connected USB stick) by mains switching.
• Contollers in Windows CE systems are automatically restarted.
• The backup selected is restored.
9. After the boot-up of the controller: Remove the USB stick from the controller.

Note!
Cabinet controllers with a DVI interface require an external Monitor Panel.