Lenze Backup & Restore Data saving and restoring - Manual (Page 30)

4 Creating a backup & carrying out recovery
4.2 Carrying out restore and auto-restore
30
Lenze · Backup & Restore · Software Manual · DMS 1.3 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.2.3 Alternative: »WebConfig«

Tip!
Use the »WebConfig« if the controller does not have a DVI interface or if no Monitor Panel
is connected.

How to carry out a restore:
1. Connect the USB stick to the controller.
2. Start the »WebConfig«.
3. Navigate to the Backup Restore menu button.
4. Select the Restore Update menu item
5. Select the Restore main action in the display area..
6. Select the desired display area of the backup/update files from the selection list.
• Via this setting you can select the available backups 1 to 10, 11 to 20, or 21 to 30.
• Up to ten backups can be shown in the display area.
Note: If more than 30 backups are available on a USB stick, only the first 30 backups can be
selected via the »WebConfig«.
The selection of a backup is to be confirmed via the Accept button.
7. Select a backup from the selection list.
Further information:  Components of the backup designation ( 22)
8. Select the Start Restore Update action.
9. Click on Accept.
• The control file is written to the USB stick.
• The backup selected is restored. (For purposes of safety a backup is created beforehand.)
• After the restore process, the controller will be restarted.