Lenze Backup & Restore Data saving and restoring - Manual (Page 40)

5 Diagnostics
5.3 Event of an error: Controller c300/p300 does not start
40
Lenze · Backup & Restore · Software Manual · DMS 1.3 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.3 Event of an error: Controller c300/p300 does not start
If Controller c300 or p300 does not start, the Lenze standard settings can be activated with the Reset
button.

How to activate the Lenze standard settings:
1. Switch off voltage supply.
2. Activate Reset button.
3. When the Reset button is activated, switch on voltage supply and keep the Reset button
pressed for at least 10 s.
• If the Error LED (green/red) is blinking after this action, manual mains switching is
required.
• The controller must be disconnected from the mains supply until all LEDs have gone off.