Bryant LEGACY 580J - Manual (Page 3)

3
FEATURES AND BENEFITS
S Two stage cooling capability with independent circuits and control.
S Round tube/plate fin (RTPF) or NOVATION all aluminum condenser (outdoor) coils. Special coil--coating also available
for coastal and industrial environments
S EER’s up to 10.8.
S IEER’s up to 12.0.
S Gas heating efficiencies up to 81% thermal efficiency.
S Dedicated vertical and horizontal air flow duct configuration models. No field kits required.
S Utility connections through the side or bottom. Bottom connections are also in an enclosed environment to help prevent
water entry.
S Standardized components and layout. Standardized components and controls make service and stocking parts easier.
S Scroll compressors on all units. This makes service, stocking parts, replacement, and trouble--shooting easier.
S Proven Acutrol refrigerant metering system.
S Easy--adjust, belt--drive motor available. Bryant provides a factory solution for most points in the fan performance table.
Motor assembly also contains a fan belt break protection system on all models and reliable pillow block bearing system
that allows lubrication thru front of the unit.
S Single--point gas / electrical connection.
S Sloped, composite drain pan sheds water; and won’t rust.
S Standardized controls and control box layout. Standardized components and controls make stocking parts and service
easier.
S Clean, easy to use control box.
S Color--coded wiring.
S Large, laminated wiring and power wiring drawings which are affixed to unit make troubleshooting easy.
S Single, central terminal board for test and wiring connections.
S Fast--access, handled, panels for easy access on normally accessed service panels.
S “No--strip” screw system guides screws into the panel and captures them tightly without stripping the screw, the panel, or
the unit.
S Mechanical cooling (115_F to 30_F / 46_C to --1_C) standard on all models. Low ambient controller allows operation
down to --20_F / --29_C
S Redundant gas valve for two stage gas heating capacity control with induced--draft flue exhaust design to help ensure no
flue gas can escape into the indoor air stream.
S Exclusive IGC solid state gas controller for on board diagnostics with LED error code designation, burner control logic
and energy saving indoor fan motor delay.
S 2--in (51mm) disposable filters on all units, with 4--in (102mm) filter track field--installed.
S Refrigerant filter--drier on each circuit.
S High and low pressure switches. Added reliability with high pressure switch and low pressure switch.
S Many factory--installed options ranging from air management economizers, 2 position dampers, manual outdoor air
dampers, plus convenience outlets, disconnect switch and smoke detectors.
S Factory--installed Perfect Humidityt dehumidification system. Available on RTPF condenser coil models only.
S Standard Parts Warranty: 10 year aluminized heat exchanger, 5 year compressor, 3 year NOVATION condenser coil, 1
year others.
580J