Bryant LEGACY 580J User Manual
Page 5
5
Table 1 – FACTORY--INSTALLED OPTIONS AND FIELD--INSTALLED ACCESSORIES
CATEGORY
ITEM
FACTORY
INSTALLED
OPTION
FIELD
INSTALLED
ACCESSORY
Cabinet
Dedicated Vertical Air Flow Duct Configuration
X
Dedicated Horizontal Air Flow Duct Configuration
X
Thru---the---base electrical or gas---line connections
X
Coil Options
Cu/Cu (indoor) coils
X
Pre---Coat (outdoor) coils
X
E---coated (outdoor & indoor) coils
X
Humidity Control
Perfect Humidity™ Dehumidification System
X
Condenser Protection
Condenser coil hail guard (louvered design)
X
X
Controls
Thermostats, temperature sensors, and subbases
X
RTU Open protocol controller
X
Smoke detector (supply and/or return air)
X
X
Time Guard II compressor delay control circuit
X
Phase Monitor
X
Economizers
& Outdoor Air
Dampers
EconoMi$ert IV (for electro---mechanical controlled RTUs)
X
X
EconoMi$ert2 (for DDC controlled RTUs)
X
X
Motorized 2 position outdoor---air damper
X
X
Manual outdoor---air damper (25%)
X
X
Barometric relief
1
X
X
Barometric hood (Horizontal economizer)
X
Power exhaust–centrifugal blower
X
X
Economizer Sensors
&
IAQ Devices
Single dry bulb temperature sensors
2
X
X
Differential dry bulb temperature sensors
2
X
Single enthalpy sensors
2
X
X
Differential enthalpy sensors
2
X
Wall or duct mounted CO
2
sensor
2
X
Unit mounted CO
2
sensor
2
X
4---in Filter Track Assembly
X
Gas Heat
Propane conversion kit
X
Stainless steel heat exchanger
X
High altitude conversion kit
X
Flue Discharge Deflector
X
Indoor Motor & Drive
Multiple motor and drive packages
X
Low Ambient
Control
Winter start kit
3
X
Motormaster head pressure controller
3
X
Power
Options
Convenience outlet (powered)
X
Convenience outlet (unpowered)
X
Non---fused disconnect
4
X
Roof Curbs
Roof curb 14---in (356mm)
X
Roof curb 24---in (610mm)
X
NOTES:
1. Included with economizer.
2. Sensors used to optimize economizer performance.
3. See application data for assistance.
4. Non---fused disconnect switch cannot be used when MOCP electrical rating exceeds 70 amps at 460/575 volt and 150
amps at 208/230 volt. Bryant Packaged RTUBuilder selects this automatically.
580J