MTS SWIFT 40 Sensor - Manual (Page 97)

Road Simulator
SWIFT 40 Sensors Installing the Transducer 97
Equipment required
This procedure requires one person. To install the transducer, you will need the
following equipment:
• Hub adapter
• Modified rim
• Spindle housing adapter plate
• Connector housing
• Locating pins
• Small set of hex-head wrenches (both English and metric)
• Metric socket head drive set (up to 14 mm) with extension
• Molykote g-n paste (MTS part number 011-010-207)
• Bolts
For SWIFT 40A Transducer
44 size M10 X 1.5 mm (inner hub and outer ring)
4 size M8 X 1.25 mm
4 size M5 X 0.8 mm
lug nuts
For SWIFT 40T Transducer
24 size M10 X 1.5 mm
20 size M14 X 2.0 mm
4 size M8 X 1.25 mm
4 size M5 X 0.8 mm
Lug nuts
• Torque wrenches, capable of the following ranges:
28–54 N•m (20–40 lbf•ft),
81–156 N•m (60-115 lbf•ft);
7 N•m (60 lbf •in)
• Cables (transducer and BNC, plus customer-supplied from transducer
interface to data recorder)
• Tie wraps
• Data recorder
• 12 V power supply (for example, a car battery)