MTS SWIFT 40 Sensor - Manual (Page 99)

Road Simulator
SWIFT 40 Sensors Installing the Transducer 99
Note To minimize negative clamping effects, you must torque the bolts in the
sequence shown.
Bolt Torque Sequence
C. Following the sequence shown in the previous figure for the transducer
being installed, torque the twenty-four M10 (for SWIFT 40A) or M14
(for SWIFT 40T) outer hub bolts in two increments as shown in the
previous table. See the previous note.
4. Bolt the transducer/hub adapter to the road simulator fixture.
(Refer to the documentation provided with the road simulator.)
5. Repeat steps 1 through 4 for each corner.
6. Install the vehicle on the road simulator.
Refer to the instructions in your road simulator operation manual.
7. Attach the connector housing (or the slip ring bracket and slip ring) to each
transducer.
B OLT S IZE
T ORQUE I NCREMENT M8 M10 M14
1st Increment 14 N•m (10 lbf•ft) 27 N•m (20 lbf•ft) 81 N•m (60 lbf•ft)
Final Torque 27 N•m (20 lbf•ft) 54 N•m (40 lbf•ft) 156 N•m (115 lbf•ft)
Inner Bolt Pattern
Bolts A–D are M8
Bolts 1–24 are M10
A
D
B
C 1 5 9
17
13
24
20
12
7
3
15
22
18
10
6 2
14
23
19
11
8
21
16
4
4
16
17
9
5 1
13
20
12
7
3
15
18
10
6 2
14
19
11
8
SWIFT 40
Viewed from Pilot Side
Outer Bolt Pattern
All Bolts are:
M10 for Aluminum Transducers
M14 for Titanium Transducers
S40-16