Orbit Baby Toddler Car Seat G2 - Manual (Page 25)

Rear
-facing Installation
48
48
Rear
-facing Installation
49
49
49
49
facing strip at the back of the car seat,
and that the FRONT OF VEHICLE arrow
will face the front of your vehicle (Photo
D).
3. Slide both brace rods evenly into the
brace plug openings in the shell until
the brace is fully inserted and you
cannot see the brace rods anymore
(Photos E and F).
4. To lock the brace, first push the locking
knob in, then turn (Photo G). Pull on
the brace to ensure that it is locked in
position.
NOTE: A small amount of
movement is normal, but the
brace should not pull off.
5. Install the remaining brace on the other
side of the car seat by following steps
1-4.
NOTE: The Toddler Car Seat G2
can still be used on the Orbit
Stroller when the braces are
installed. Place the car seat
either forward- or rear-facing.
However, the braces prevent the car
seat from rotating on the stroller
and can interfere with the Stroller
Panniers accessory. To restore full
rotation on the Orbit Stroller, remove
the braces and store them in the
Stroller Cargo Pod™.
NOTE: The Toddler Car Seat G2
cannot dock onto the Orbit Baby
car seat base when the braces are
attached.
D G
E
F