Orbit Baby Toddler Car Seat G2 - Manual (Page 27)

Rear
-facing Installation
53
53
Rear
-facing Installation
52
52
closes. The LATCH leash will wrap
around the car seat on this same side.
Close the clip on the back of the rear
access panel to secure.
6. Position the car seat rear-facing on the
vehicle seat. The car seat should face
the rear of the vehicle. The FRONT OF
VEHICLE arrow on the braces should
point to the front of your vehicle.
7. Open the upholstery lower panel
marked by the blue dot (Photo D).
8. Fully open both arms of the blue belt
lock-off clamp that will be closest to
the center of the vehicle in the final
installation (Photo E).
NOTE: If installing the seat in the
center position, open both arms of
either lock-off clamp. Only one clamp
is needed for a secure installation.
9. Feed the LATCH belt through the rear-
facing belt path in the car seat shell
Installating the Car Seat: With LATCH cont’d
and the open arms of one of the blue
lock-off clamps. Start at the outside of
the shell and finish on the other side of
the car seat. Ensure that the logo on the
LATCH connectors face the outside of
the vehicle and the UP arrows face the
roof of the vehicle (Photo F). Center the
colored stitch line of the LATCH Belt on
the car seat shell (Photo G).
NOTE: If the crotch belt is in one
of the two shell slots closest to the
seat back, the LATCH belt should
run in front of the crotch belt. With
the crotch belt in the most forward
shell slot, the LATCH belt should be
positioned behind the crotch belt.
10. Close the lock-off clamp to secure the
LATCH belt by pressing down both
clamp arms firmly and locking them in
place. (Listen for a CLICK) (Photo H).
11. If the vehicle seat back is adjustable,
lock the vehicle seat back into the
upright position.
D
E
F
G
H
I