Orbit Baby Toddler Car Seat G2 - Manual (Page 38)

Forwar
d-facing Installation
74
74
Forwar
d-facing Installation
75
75
1. Attach the Side Impact Braces in a forward-
facing position: see pages 71-73.
2. To access the LATCH belt, open the rear
access panel by unclipping the back clip
(Photo A).
3. Remove the LATCH connectors from their
pockets (Photo B). The LATCH belt is
permanently attached to the car seat by a
black strap called the LATCH leash.
If you will be attaching the top tether later
(recommended; refer to page 87), unclip
and remove the tether hook from the
secured ring (Photo C).
4. For ease of installation, lengthen the
!
WARNING
!
Refer to your vehicle manual for the
maximum weight rating of its lower
LATCH anchors. Unless a higher
weight is specified by the vehicle
manufacturer, only install your
Toddler Car Seat G2 with LATCH until
your child reaches 40 lbs (18 kg).
Installing the Car Seat:
With LATCH
1. Un-install the Toddler Car Seat G2 from
your car or have the car seat docked
securely either directly forward- or rear-
facing on the Orbit Stroller.
2. Turn the locking knob on the Side
Impact Brace to the UNLOCKED
position by first pushing it in, then
turning (Photo A).
3. Pull out evenly on both sides of the
brace until the brace rods disengage
completely from the car seat shell
(Photo B).
4. By rotating one brace around, you can
nest the braces together in their storage
position (Photo C). Store them in the
Cargo Pod of your Orbit Stroller or
another safe place for later use.
Removing the Side Impact
Braces
back clip
rear access panel
A
B
LATCH connectors
C
A
B
C