Orbit Baby Toddler Car Seat G2 - Manual (Page 39)

Forwar
d-facing Installation
76
76
Forwar
d-facing Installation
77
77
LATCH belt by pressing the grey push-
button adjusters on the buckles and
pulling on the belt.
5. When closing the rear access panel,
look for the notches on the sides near
the bottom of the panel (Photo D).
Position the LATCH leash in either the left
or right notch so that the panel closes.
The LATCH leash will wrap around the car
seat on this same side. If using the top
tether (recommended, refer to page 87)
fully pull the it out of the pocket. Close
the rear access panel and secure it with
the clip.
6. Position the car seat forward-facing on
the vehicle seat. The car seat should
face the front of the vehicle. The FRONT
OF VEHICLE arrow on the braces should
point to the front of your vehicle. If using
the top tether, drape it over the rear of the
vehicle seat; it will be secured later.
7. Unbuckle the restraint harness on the seat.
Lift the upper upholstery panel marked
by the red dot (Photo E). It will stay out of
Installing the Car Seat: With LATCH
cont’d
the way by wedging it into the sides of the
upholstery (Photo F).
8. Fully open both arms of the red belt lock-
off clamp that will be closest to the center
of the vehicle in the final installation (Photo
G).
NOTE: If installing the seat in the center
position, open both arms of either lock-
off clamp. Only one clamp is needed
for a secure installation.
9. Feed the LATCH belt through the forward-
facing belt path in the car seat shell and
the open arms of one of the red lock-off
clamps. Start at the outside of the shell
and finish on the other side of the car
seat. Ensure that the logo on the LATCH
connectors face the outside of the vehicle
and the UP arrows face the roof of the
vehicle. (Photo H). Center the colored
stitch line of the LATCH Belt on the car
seat shell (Photo I).
10. Close the lock-off clamp to secure the
LATCH belt by pressing down both
D
E
F
G
H
I