Orbit Baby Toddler Car Seat G2 - Manual (Page 28)

Rear
-facing Installation
55
55
Rear
-facing Installation
54
54
12. Center the car seat on the vehicle seat
between the vehicle LATCH anchorages
(Photo I), making sure the area between
the vehicle LATCH anchorages and the
areas under and behind the car seat are
clear of obstructions.
13. Check that the car seat is level by
looking at the level indicator on the
Side Impact Brace (Photo J). The white
indicator ball must be in the blue level
zone on the brace (Photo K). If the white
indicator ball is not in the blue level zone
(Photo L), try any of the following:
Remove the car seat. Position a a.
rolled towel under the back of the
Installating the Car Seat: With LATCH cont’d
⚠WARNING⚠
Death or Serious Injury Can Occur
To prevent ejection, the car
seat must be properly reclined.
The white level indicator ball in
the Brace must be in the blue
level zone when installed.
brace (Photo M), The towel should
be compressed as the LATCH belt is
tightened.
Install the car seat in a different
b.
vehicle seating position.
Seek assistance from one of the
c.
resources in the Need Help Securing
Your Car Seat? section.
14. Attach both LATCH connectors to their
corresponding vehicle anchorages on
each side of the car seat. With the
connectors oriented with the logo facing
outward and the UP arrows facing the
roof of the vehicle, push them straight
onto the metal bars until you hear and
feel a
CLICK (Photo N).
15. Pull out on each LATCH connector to
be sure it is locked onto the vehicle’s
anchorage point.
16. Tighten the LATCH belt around the car
seat by pushing down on alternating
sides of the car seat rim while pulling on
the LATCH belt loop to remove all of the
slack (Photo O).
J M
K N
L O