Orbit Baby Toddler Car Seat G2 - Manual (Page 29)

Rear
-facing Installation
57
57
Rear
-facing Installation
56
56
You know that you have reached the
optimal tightness when you tug on
the car seat at the belt path (Photo P),
and the car seat does not move more
than 1 in (2.5 cm) in any direction.
17. RE-CHECK the following to make sure
that the car seat installation is secure:
CHECK a. that the car seat installation
is not loose. It should not move
by more than 1 in (2.5 cm) in any
direction when checked at the belt
path.
CHECK
b. that the car seat is level by
making sure that white indicator ball
is in the blue level zone on the Side
Impact Brace (Photo Q).
If the car seat is loose or if the white
indicator ball is not in the blue level
zone, remove and re-install the car seat
beginning at Step 11.
18. Close the lower upholstery panel.
Installating the Car Seat: With LATCH cont’d
P
Q
To un-install the car seat and remove it
from your vehicle:
1. Lengthen the LATCH belt by pressing
the grey push-button adjuster on the
buckle and pulling on the belt (Photo
A).
2. Push and hold the red button on each
LATCH connector and pull it off the
vehicle LATCH anchorage (Photo B).
Store the LATCH connectors in the rear
access panel or in the LATCH pockets
if using the car seat on the Orbit Stroller
(Photo C).
3. Grasp the car seat firmly with one hand
holding a carry handle and the other
positioned near the padded front of the
seat.
Un-installing the Car Seat:
With LATCH
A
B
C