Orbit Baby Toddler Car Seat G2 - Manual (Page 26)

Rear
-facing Installation
51
51
Rear
-facing Installation
50
50
51
51
1. Un-install your Toddler Car Seat G2 from
your car or have the car seat docked
securely either directly forward- or rear-
facing on the Orbit Stroller.
2. Turn the locking knob on the Side
Impact Brace to the UNLOCKED
position by first pushing it in, then
turning (Photo A).
3. Pull out evenly on both sides of the
brace until the brace rods disengage
completely from the car seat shell
(Photo B).
4. By rotating one brace around, you can
nest the braces together in their storage
position (Photo C). Store them in the
Cargo Pod of your Orbit Stroller or
another safe place for later use.
Removing the Side Impact
Braces
Before you install the car seat in your
vehicle, make sure the vehicle is parked on
level ground.
1. Attach the Side Impact Braces in a rear-
facing position: see pages 47-49.
2. To access the LATCH belt, open the rear
access panel by unclipping the back clip
(Photo A).
3. Remove the LATCH connectors from
their pockets (Photo B). The LATCH belt
is permanently attached to the car seat
by a black strap called the LATCH leash.
4. For ease of installation, lengthen the
LATCH belt by pressing the grey push-
button adjusters on the buckles and
pulling on the belt.
5. When closing the rear access panel,
look for the notches on the sides near
the bottom of the panel (photo C).
Position the LATCH leash in either the
left or right notch so that the panel
Installing the Car Seat:
With LATCH
A
B
C
A
B
C
back clip
rear access panel
LATCH connectors