MacDon D65 - Manual (Page 26)

LIGHTS
169784 24 Revision A
C. INSTALL SPLICE
This modification is applicable to transport lights
without a module that were manufactured up to
the 2013 model year.
The lighting harness at the endsheet transport
light needs to be modified to include a splice at the
6-pin flat connector. Refer to the electrical
schematic on page 27.
a. Locate the 6-pin flat connector (A) at the end of
the header portion of the electrical harness (B).
b. Unclip and pull back the TPA (Terminal Position
Assurance) clip (C) on connector (A).
c. Locate the wire (D) inside the conduit from pin
position “A” on connector.
d. Pull out a short length to accommodate the splice.
e. Obtain a length of wire (E) the same gauge as the
existing wires for the splice.
f. Attach a pin connector (F), similar to the one
shown to the splice (E).
g. Pull out the green weather plug (G) from position
“F” on connector (A).
h. Insert splice (E) at position “F”.
i. Connect other end of splice to wire (D) from pin
position “A” with a T-type connector, or by
soldering the splice to the existing wire.
j. Insert the connection into the conduit and wrap the
conduit with electrical tape.
k. Reattach the TPA clip (C) on the connector.
B
A
A
C
F
E
F F
G
D
F
A
E
F
A
CONNECTOR SHOWN WITH CAP REMOVED