RKI Instruments GX-2012 - Manual (Page 78)

74 • Set Window
5. Click the Set button to display the Set Window. Use the GX-2012
Status Frame and the Gas/Sensor Frame to change parameters stored
in the instrument.
6. To change the serial number stored in the instrument, click the serial
number field and use the backspace key to remove the current entry,
then type the new serial number.
7. To change the station ID or user ID, click on the down arrow in the
desired box and select a new station ID or user ID from the list. The
available station and user IDs are ones that are stored in the
instrument’s memory.
8. To change the datalogging trend interval time, click on the down arrow
in the Interval Trend Time box and select the desired interval time in
seconds. The available choices are 10, 20, 30, 60, 180, 300, and 600
seconds.
9. To change the channel parameters, double-click the field you wish to
change (e.g. H2S AutoCal.) to select it, then type the new information.
10. After you have finished entering new parameters, you must upload this
Figure 74: Set Window
Click to upload changes to instrument