SPYPOINT TINY-W3 - Manual (Page 10)

10
Power • Camera
The battery level is shown in the REPORT mode (4/4 = full, 1/4= low) and
in the bottom right corner of the screen when the camera is in TEST mode.
When the battery level shows 2/4 or when a single line remains (see figure
below), the camera will continue to take photos but we strongly recommend
to change the AA batteries or charge the lithium battery pack before they
are empty. If a video is being recorded and the batteries level reaches 0%,
the camera saves the file before shutting down.
AA BATTERIES
This camera requires 6 AA batteries (1.5V). The use of alkaline or lithium
batteries is strongly recommended. During the installation of the AA
batteries, slide the battery switch to ALK (i.e. alkaline). Insert the batteries
in the removable battery holder as indicated and insert it inside the camera
(see figure below). Battery polarity must be followed.
Please note that the voltage of rechargeable AA batteries (1.2V) is
insufficient to power the SPYPOINT camera. We also recommend the
use of new batteries to ensure maximum performance of the camera.
LITHIUM BATTERY PACK
This SPYPOINT camera can be powered by a rechargeable lithium battery
pack LIT-09/LIT-C-8 (sold separately, p.41). This type of battery is less
affected by cold temperatures and lasts up to 3 times longer than an alka-
line batteries. During the installation of the lithium battery pack, slide the
battery switch to RECH. Insert the battery in the removable battery holder
and insert it inside the camera (see figures above).
EXTERNAL (12V)
This camera can also be powered by an external 12-volt DC input such as
a 12-volt battery (KIT-12V, BATT-12V or KIT6V/12V) or a 12-volt adapter
(AD-12V), each sold separately (p.41). During the installation of a 12-volt
connection, slide the battery switch to ALK (the AA batteries can remain
safely inside the camera). If combined with a lithium battery pack, slide the
battery switch to RECH. For available accessories, see p.41.
SOLAR PANEL
This camera also offers the possibility to connect a solar panel (SP-12V sold
separately, p.41) to maintain the charge of the lithium battery pack
(sold separately, p.41). While installing the rechargeable lithium battery
pack, slide the battery switch to RECH to activate the charging system of
the solar panel.
Battery switch position (depending on the power source)
Power source Battery switch position
• 6AA
• 12V
• 12V + 6AA
ALK
• LIT-09 *
• 12V + LIT-09 *
• Solar panel + LIT-09 *
RECH
* Rechargeable lithium battery pack, sold separately (LIT-09) or with a
charger (LIT-C-8).
TIME BATTERY
The camera has a CR2032 lithium button battery which saves the time and
date. To replace the battery:
1. Turn off the camera and remove it from the housing.
2. Using a flat screwdriver, push the tab to the left.
3. While pushing the tab to the left, remove the compartment of the camera.
4. Replace the battery, the polarity must be respected (side + facing up).
Insert connectors
first
6 alkaline AA batteries Lithium battery pack
LIT-09/LIT-C-8
Connectors Connectors