SPYPOINT TINY-W3 - Manual (Page 31)

31
Power • Controller
(BLACKBOX-4G)
SYNCHRONIZE A NEW CAMERA TO THE CONTROLLER:
Preparing the camera:
1. Set the name of the camera:
• In the SETTINGS menu, choose the "Camera ID" option and press OK.
• Determine the name of the camera by pressing the  or  buttons to
change the letter and press OK to go to the next space.
2. Continue changing other parameters of the camera as needed.
3. To enable communication with the controller:
• Still in the SETTINGS menu, select the "Wireless" option and press OK.
• Select "On" and confirm the selection by pressing OK; then on BACK to
return to the previous menu.
4. Select the SIGNAL mode
and press OK. The camera searches for the
controller.
Preparing the BLACKBOX-4G controller:
1. In the MANAGE CAMERAS menu, select the "Resync" option and press
OK.
2. A green checkmark will appear next to the "Resync" option to indicate
that the synchronization is successful. The name of the camera appears
at the top of the options.
USING MULTIPLE CONTROLLERS IN THE SAME AREA:
When multiple controllers are installed in the same area of transmission, it
is necessary to manually synchronize each controller with its camera(s) in
a different group.
To do this:
1. On the controller, select the MANAGE CAMERAS menu and press OK.
2. Hold down the  button for 3 seconds to reach the group option located in
the upper right corner of the screen controller.
3. Use the  or  buttons to assign a new group to each additional controller
(maximum 5 BLACKBOX-4G) and press OK.
4. Synchronize the cameras to the new group (follow the steps in the
PREPARING THE CAMERA (p.31) and PREPARING THE BLACKBOX-4G
CONTROLLER (p.31) sections).
Notes:
• It’s possible to synchronize up to 10 cameras to a single controller.
• If the name of the camera is changed, it is necessary to resynchronize
the devices by following the steps in the PREPARING THE CAMERA (p.31)
and PREPARING THE CONTROLLER (p.31) sections.
Note: A camera cannot be synchronized to multiple controllers.
Group 1
CAMERA01
Re Sync
Settings
Get Camera Status
Start Camera
Stop Camera
Range Test √
Tip: Use a name that makes it easy to identify the camera
(e.g. : cottage front, house backyard, etc.).