SPYPOINT TINY-W3 - Manual (Page 18)

18
Settings • Camera
Wireless: (TINY-PLUS, TINY-W BF , TINY-W 3 , TINY 4G )
(On/Off)
Enables or disables the wireless transmission of photos to the BLACKBOX
receiver (TINY-W BF ), to the BLACKBOX-D controller (TINY-PLUS, TINY-W 3 )
or to the BLACKBOX-4G controller (TINY-PLUS, TINY 4G ).
When the transmission is enabled:
• Only photos are transmitted to the receiver and to the controller, not
videos.
• The quality of the photos recorded on the receiver and the controller is
reduced to maximize transmission:
8 or 10MP = 800 x 600 pixels
5MP = 640 x 480 pixels
3MP = 320 x 240 pixels
• When the TIME LAPSE mode is enabled, the photos are sent to the
receiver and to the controller except for the "30s" setting.
• When the delay setting "10s" is selected, the time between each
detection is calculated when the transmission is completed. For
example, if the transmission takes two seconds, the time between the
two detections is 12 seconds.
Note: When the "Wireless" option is activated, it is only possible to take up
to 2 consecutive shots (TINY-PLUS, TINY-W 3 , TINY 4G ) .
Delay:
(10s/1m/3m/5m/10m/15m/30m)
Allows the user to choose the time interval between each detection before
the camera records the next photo or video. A longer delay minimize the
number of photos taken and maximize the battery life. A shorter delay
maximize the number of photos taken but requires more battery power.
The shorter times interval are recommended when the cameras is used
for security purposes.
Additional setting:
It is possible to decrease the delay between detections to 10 seconds
(instead of 1 minute) by using the following procedure.
Note that the battery life will be affected.
1. Turn OFF the camera.
2. Press and hold the  button and turn ON the camera.
3. "10sec enabled" appears on the screen meaning the minimum delay is
now 10 seconds. If this option is used, the 30 minute delay disappears.
4. To reset the camera to 1 minute delay, follow the same procedure.
"10sec disabled" appears on the screen. (see next figure)
Multi-shot:
(1/2/3/4/5/6 consecutive shots)
Takes up to 6 consecutive shots at each detection, with a 10-second delay
between each photo. This option allows the user to get up to 6 photos
from different angles when the camera is in PHOTO mode.
Note: When the "Wireless" option is activated, it is only possible to take up
to 2 consecutive shots (TINY-PLUS, TINY-W 3 , TINY 4G ) .
Video length:
(10s/30s/60s/90s)
Allows the user to select the duration of the recording when the camera
is set in VIDEO mode.
Language:
(English/Français/Deutsch/Italiano/Español)
Allows the user to select a language for the camera menus.
P INT SPY INT P SPY
10SEC ENABLED
P INT SPY INT P SPY
10SEC DISABLED
P INT SPY INT P SPY
10SEC ENABLED
P INT SPY INT P SPY
10SEC DISABLED
10 s delay 1 min delay