SPYPOINT TINY-W3 - Manual (Page 24)

24
Setup • Receiver
(BLACKBOX)
Note: In the minute following turning on the receiver, the test light of the
receiver flashes. The first 8 seconds allows the user to know the battery
status (p.11). Then for the rest of the time, the test light flashes rapidly
to indicate the synchronization period.
Note: After a synchronization or when the test light turns off (after 60
seconds), the receiver can’t be synchronized unless it is turned off and
on again.
MANUALLY SYNCHRONIZING ONE OR MULTIPLE SETS (TINY-W BF
CAMERA/BLACKBOX RECEIVER) IN THE SAME PERIMETER
To change the synchronization channel or to install one or many sets
(TINY-W BF /BLACKBOX receiver) in the same area of transmission, it is
necessary to manually synchronize each camera with its receiver on a
different channel.
1. Turn on the first camera and choose the SIGNAL mode.
2. Turn on the first BLACKBOX
receiver.
3. Choose the Channel 1 option on the camera and press OK.
4. Use the  and  buttons to select a channel and press OK.
5. Choose the
Sync option on the camera and press OK.
6. The camera synchronizes with the powered receiver and the
icon Sync goes from red to green when the synchronization
is complete.
7. Turn off the camera and the corresponding receiver.
8. Repeat these steps for each additional set, up to 9 sets (TINY-W
BF /BLACK-
BOX receiver) can be matched in a same perimeter of 250ft.
Sync